NitorLACK Compound Cut

NitorLACK Compound Cut removes scratches caused by finishing sandpaper (2000-3000) and brings out the surface shine

• Designed for polishing all types of varnishes, whether water-based, nitrocellulose or polyurethane.
• Water-based and silicone-free.
• It is necessary to shake vigorously for a few minutes before use.
• This product is a cutting polish, and it is necessary to complement it after use with Superfinish Polish.

This polish is a coarse-grained cutting compound.

• It is specially designed to remove all surface imperfections after finishing the varnishing and sanding process;
• Compound cut can be applied either by hand or by machine, with its respective white cutting sponge of 80 or 150 mm.

The result will always be better if you use a machine, but you should not exceed 1200 to 1500 revolutions, otherwise you may overheat the surface. It is therefore advisable to check the surface temperature from time to time. Eis designed to keep the surface temperature low when polishing and removes marks permanently, although once the application is finished it is recommended to wipe off the excess with a damp cloth.

IMPORTANT:

This two-phase polish should be combined after use with superfinish to achieve the optimum degree of brightness to your guitar.

Shake vigorously before use.